This ad expired 81 days ago.
Car has been on here for a long time.Since there was no takers on the Chevelle.The car is being traded for a 57 Chevy from back home. Thanks for looking....
Above Added: Mon November 14, 2011, 12:41 pm EST
I have added a complete set of doors,Ignition key, glove box key and trunk key set for it now. Also new under hood insulation kit as well.
Above Added: Thu October 13, 2011, 3:02 pm EST
Since nobody has bought the car. I am in the process of adding the new stainless fuel lines in. Once that is completed. I will install the motor and trans.Send the carb out to get rebuilt. Then I will get it running. Now the price goes up.
Above Added: Mon August 15, 2011, 11:18 am EST
New Headman BB coated headers are added now. Crossmember blasted, etched primed and painted.
Above Added: Sat July 23, 2011, 5:08 pm EST
Floors are cleaned up and repaired. Etched primed and painted underneath. I ended up picking up a new Stainless fuel line. So I will order a new clip kit for the gas and return line and install. After that the motor and trans will be ready to drop in.
Above Added: Thu July 21, 2011, 8:06 am EST
New brakes and lines are completed in the front. Rear end is painted now too.
Above Added: Sun June 26, 2011, 9:55 am EST
I forgot to mention that the carb is the correct part# 7029200. Lucked out in finding it a swap meet.. Front springs are back in now..
Above Added: Mon June 13, 2011, 2:15 pm EST
The old M/T valve covers have been retored. I can also throw in the deal a complete cruise control setup? Its up to the buyer?
Above Added: Tue May 24, 2011, 10:45 am EST
The new stainless lines are in. The new BB springs will be in soon. New torsion links and bushing kit to finish the front end rebuild will be installed. Then the Motor and trans. The casting on the motor is 272 on the back of the block. The Heads are 063 castings with early production build. The front deck of the block is JC coded for 350 Hp 396. I did not paint the intake thou. I figure someone would throw aluminum intake on it. The intake is dated coded to the motor too. Carb will need to be rebuilt. New water and fuel pump will be added soon before re-installing the motor and trans. Then the price will go up..
Above Added: Tue May 24, 2011, 10:38 am EST
I have checked the 12 bolt gear. It's not what I would want for the car. It has CN on the axle is 2:56 I already have a series 3 posi used. Will supply a 3:31 GM gear set with the car. Being an AC car and the price of gas these days. This will make it a nice cruiser for the road.
Above Added: Thu April 7, 2011, 8:44 am EST
Car back in the shop so I can add the new BB springs. Picked up a drivers front bumper and rear. New rings for the 14 inch SS wheels I have for the car. Also a used Posi unit for the rear end. Checked the fuel line and its in great shape. Will not need to replace. Added the rebuilt vaccum booster and master. Will add the new brake lines in before the motor and trans goes back in. Price will go up soon...
Above Added: Mon April 4, 2011, 11:52 am EST
added a correct working green light AM radio. Also a nicer OEM dash pad.
Above Added: Wed March 2, 2011, 6:31 pm EST
I have added a rebuilt brake booster, new master, Stainless brake lines.
Above Added: Wed February 16, 2011, 12:12 pm EST
Front Frame section cleaned up and ready for new springs to be put back in.
Above Added: Wed October 13, 2010, 7:02 pm EST
Repairs have been made to door and lower patch. Fire wall painted now.
Above Added: Sun September 12, 2010, 3:35 am EST
Added stainless exhaust from headers back to mufflers. As well mufflers. Do not have tail pipes.
Above Added: Mon August 30, 2010, 3:29 pm EST
Have a correct 350 hp 396 running motor now and a numbers matching 69 turbo 400 trans that has shift kit for the street to go with the car. Now there is a running drive train. New grill too.
Above Added: Fri August 27, 2010, 6:06 pm EST
Picked up the correct OEM bumper jack setup for it.
Above Added: Sun May 16, 2010, 9:54 pm EST
Now have a good clutch fan setup for it too.
Above Added: Sat February 13, 2010, 8:50 am EST
Now have a nice 4 core radiator,BB Fan shroud and chrome hold down plate. ALso have condenser and Evaporator and mounts.
Above Added: Sun January 17, 2010, 8:03 pm EST
I have grill and the extentions. Another lower valance that is in nicer shape. Another header panel that goes with it. I do have set of headers and partial exhaust from headers to mufflers. Need mufflers and tail pipe section to complete the exhaust system. The pic of the trunk shows the new BB springs in the box and the exhaust is layeing in the trunk too. Also the motor pictured also comes with a working turbo 400 trans too. I have all the head light buckets and nice bezels.
Above Added: Sat December 5, 2009, 9:53 am EST
If ya don't want the 396 motor for the car and wanted a low mileage 454 with new parts, NEW intake, carb, valve covers, Water pump, distributor and coil, intake, bolts, fittings Will cost ya more money but can make a deal on it too. It’s in an Elcamino now but found the right motor for it. So decided to sell this 454 BB motor. 12K for the car and this motor too.
This way ya have a complete running drive train. So call
Above Added: Tue October 13, 2009, 9:05 pm EST
Guys the motor will need to gone thru. The trans is a working turbo 400 with a truck converter. The drive shaft is from Spicer Industries. It can handle up to 650 Hp easily. IT's new! The wheels are the correct SS wheels for 69 and 70. I also have another good dash pad for it too. The firewall has been blasted and etched primed like the core support and rear end to seal it. There are boxes of new parts to car with. It has all new body bushings installed as well.New front inner fenders. Hard work done for ya....
Above Added: Tue September 1, 2009, 8:05 pm EST
Guys I have a 69 SS that needs to be restored. It is an Alabama car but the vinyl top killed the quarters. I have two new full quarters (good marks), new inner front fenders, emblems and such. The new quarters and new trunk pan and tail panel installed. New back window and Windshield kit were installed with new windsheild. It will has new body busings and be a nice straight car to start with all good body panels. The front floor section will need only minor work by the gas pedal. It has a true GM SS hood, fenders. It’s a green on green car originally. Correct color dark green console.It’s a AC, bucket seat car. I have a 396 motor and 400 trans to go with the car. This is the correct era but not numbers matching for the car. I have all the pulleys, brackets and the AC compressor and brackets. I have a correct cast iron intake too. The only thing I do not have is the carb and exhaust manifolds to make it complete. Have the disc brakes and 12 bolt rear too. If you are looking for something that is will be nice to finish and drive with AC. This is your car. Its not a take every thing off for street racing setup. Just a nice car to drive. Frame was blasted before. will need touch up. It does have the bb frame braces on it too. The front end has been replaced. I did not install the front springs so you can replace or clean up to make it a nice frame off deal. I do have new BB Springs.I have plenty of parts for this car. I do not have a new grill or front bumper for it. Title is in my name. I live near Rockford IL. $9500.00. Please call after 5pm during the week. Will not answer emails! To many scammers that can't make it in the real world. Call if your serious.
Seller Information
